...Spec E36 race car prepared. Removed seats, interior, windows, radio, all apparent sound system wiring, and all unnecessary fuses. Now the engine cranks but does not fire, and the fuel gage and engine ...
...So I'm putting new plug wires and caps on the K 1200 GT I'm restoring and I noticed a difference in Ohms between the new set and old set. My old wires with no caps are showing .2 Ohms New wires with ...
ignition key OFF, than start the motor and verify if problem remains I would recommend that you check to make shore that you replaced the bulb with the right bulb. It is common for two different bulbs
ignition on until the yellow tpc button goes out. Thats it. If this hasnt worked you have a different spec and therefore a different way of doing it! Let me know and il guide you through it. Hope this
...ignition system. Either it is a bad spark plug, or plug wire. You will need to check each spark plug for wear or cracks. The wires can be checked with an cheap OHM meter. If you don't know the specs ...
...wires and get a Ohm meter probe on them). Using a Bentleys Electrical Manual find the connection diagram for the wheel sensors to the ABS Controller. The pin designators will most likely be wrong ...
...at coil terminals. (primary coil terminals: 1 (-) and 15 (+), primary coil resistance: 0.4-0 .8 ohms; secondary coil terminal and resistance: NA). Remove coil and inspect coil ...
...ohm meter (DVOM) and a wiring diagram. Have you pulled the fuse boxes apart to check them for moisture damage? It may be localized to the ignition and starting circuit- you just have to look for it. ...
Question about 2009 5 Series
...time where it meets the hard end. The connector is under the throttle body and should read 500-600
...ignition coil from EDM I check coils and wires. Negative doesn't come from EDM. I think that's crank shaft sensor problem but engine has 2. What of 2 in crank sensor upper or lower. And please will ...
Usually answered in minutes!
789 Questions
796 Questions
708 Questions
690 Questions
600 Questions