Questions & Answers for: Ford Ranger off line

...off That is the hydraulic clutch line going to the internal slave cylinder.You will need to get a "clutch line removal tool" to take it out. You should be able to get one at a parts store. Put the ...

...off the line that connects the exhaust to the egr valve and i dont kno wat the bottom 90 connects to TOP GOES TO THE EGR OTHER GOES TO THE AIR CLEANER HOUSING IN BACK OF THE MASS AIRFLOW DUCTING .THE ...

can pull the line off. Just pull the lines then replace with the new filter. The truck will start funny at first because it will be deprived of gas for a moment but then it should be fine. HTH, Mike..

...Make sure that the brackets holding the fuel line in place on the frame are loose so that you can pull the line. Or, when you push the plastic piece in, pull the filter. It should slide off the

...line but do not take off, unbolt the cylinder and then disconnect brake line. loosely connect the brake line to the new cylinder so you do not loose much brake fluid, bolt new cylinder in and then ...

...from fuel tank special tool (about $15 at any parts store). It pushes in around the fuel line to release a clip inside , then the fuel line just slides off. Sometimes takes some wiggling and

vacume lines leaking and some blocked off making engine miss and hesitant need to find where the blocked off lines go depends on vehicle

...off go to parts store get these. they are fuel line/ac line disconnect tool use the red one i think for the fuel line. the cylinder shape part goes inside the bell of the fuel line where the circular ...

...line off of intake manifold and put line in a can of Seafoam and rev car to keep running until Seafoam is gone .white smoke wil come out of exaust during this process but it will clean out catalitic ...

...off inside the line because of the low pressure cause by the sucking action of the compressor and this boiling off reduces the temperature of the line and so the condensation forms . It will be the ...