Questions & Answers for: Ford Econoline off line

off you MUST buy the tool to do this, I bought mine at auto zone and it works great, the fuel lines are a snap on type and the ONLY way to release them is by using this tool, Be careful, the fuel will

...off with. Thanks Fuel line tool. Can be found at any auto parts store. There are muptiaple sizes, so if you get a single one, make sure it's for your vechile. However, most tools come with all proper ...

...will insert the tool into the hose ends at the snap locks, push in on the fuel line while pushing the tool into the fitting then you can slide the fitting off the fuel filter assembly. Hope this ...

need a diagram for the ignition wires. The key was broke off in the ignition you dont need a diagram because they should have a wiring plug down the line or get a thin pick and pick it out

line at the bottom of the transmisson you will need a line wrench so you don't strip the nut off, after line is loose it will pump out a half quart every 30 seconds. The lines come out of the radiator

...or release some pressure at the fuel/water separator (yellow knob). Make sure the car is turned off, or the pump will prime, and pressure will build. Good

...clips but after removing the retaining clips I still cannot seem to get the fuel lines to come off the filter. Do I need a special tool? Yes you do, The first clips you removed are the secondary ...

...it tried to turn over ya probably have it runnin by now but filter has to prime run the key on and off a few times not quick on then wait for the pump to kick off on and so on bout three times other ...

...off compressor to back condenser, is there a switch in the line that can go bad to the back condenser? Or what could cause the back condenser not to work? Fan blows fine on all speeds, just not ...

...line comes off and goes to the vacuum canister. From the canister there is a T and two lines. One goes forward to the HVAC controls. The other goes to the PVH (Pulse Vacuum Hublock) solenoid on the ...