Questions & Answers for: Chevrolet Suburban off line

Question about 1999 Suburban

1 Answer

...line on fuel rail there is a valve stem hold stem in while circulating the key on then off 10 sec. then on then off 10.sec this will clear the line then while tring to start keep held open till ...

Ad

...the fuel line off. It is a plastic ring that is split in middle and it fits over the fuel line and you push it in to the fitting and then pull them apart. They should hook you up with what you

Ad

Question about 1996 Suburban

3 Answers

...line repair kits and rear a/c block off kits for just about any vehicle readily available. I repaired my corroded lines last year and it took about 20 minutes and the rear a/c has been working great ...

off the vehicle to replace the hose. Undo the line nut on the back of the pump and undo the line nut on the steering box.. dont think the pump has to be removed to do this Line nuts are 18 mm or 16mm

Question about 1997 Suburban

1 Answer

line adapter. This is also a simple fix but you're going to need a drumlin tool cut off the old compression clamp that was press fit. Cut off the old compression fitting ring, use cation that you only

...pickup and the break lines dont match up the line on the surburban is long and im tryin to change them but dont know how Take them off with line wrenches you you see how long they are and go get

...line attaching nut near the engine area and have some one turn the key to the on position for 5 seconds. Then turn it off and repeat this process till all air has escaped Do no start the engine at ...

...line came off the bellows located behind and under the dash. Has someone been working on the blower? You'll need to look under the dash with flash light to see if you can gain access to the vacuum ...

...off for 30 seconds it runs fine for 5 miles then repeats..... Could it be the fuel pump??? fuel pump strainer??? sending unit??? rarely do i get it over 35mph before it mess up again sounds like you ...

...tube and condenser. but i can not get to cool. the line that come off of the condenser is the only line that gets cold. My first guess would be not enough freon.  What are the gauge readings

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...