...line off the whole master cylinder is not going to drain completly out, only what is in that line itself you will lose. and about the air; its simply putting the new line on and bleading it like you ...
Question about 2001 XL 1200 C Sportster Custom
...line is not from the bottom of your carb? Your float bowl is stuck and not closing off the overflow valve. You need to take the carb off and remove the float bowl you either have some crude in it or ...
...line cam off (rotted off) the manifold. Now i replaced the short line on a tee that goes to the manifold and the long line goes to the petcock, there is a short line on the tee. I cant find where to ...
Question about 2000 XL 1200 C Sportster Custom
line came off one side is still connect to the carbutor Where do the line connect from the carbutor This is a 99 HD Sporter XL The fuel line runs from the fuel petcock to the carburetor. On either end
...line with hemostats. Cut the factory clamp off and pull the hose off. Put the 2 inch plug on the tank,and that will stop the gas from coming out. put a hose clamp on it if you want so it don't leak. ...
...line. This will allow the brakes to be applied due to the high pressure but restrict the bleeding off of the pressure. I've seen this many times and this is my best guess as to the problem, ...
line off the bottom of it and two at the top as best as I can remember. Of course the line off the bottom of the tank was the feed line and goes to the inlet of the oil pump. As best as I can remember
Question about 2003 XLH 883 Sportster
line closed off. 11. Restricted, blocked or kinked fuel line. 12. Failed fuel pump, pressure regulator and or fuel injectors. For a prime suspect please visit website below and good luck: Codes 1130cc
Question about 2007 FXDB Dyna Street Bob
...off then comes right back on. Fuel line in the gas tank coming from the fuel pump has a hole in it or is leaking around the connection where the line and the fuel pump connect. It is losing fuel ...
Question about 2003 FLHTCUI Electra Glide Ultra Classic
...cut them off with a set of side cutters. Twist the line back and forth while pulling on it. You will need a special tool to clamp the lines if you replace the old clamps with new ones from
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions