Question about 160 CC Honda OHC Engine 21 in
starts on choke but dies when moved off choke Starts fine when on choke, but when the throttle is moved to run, the engine dies. If it will start on choke and die when choke is taken off...the carb ...
number of problems. Try your friendly neighborhood chainsaw shop. Start Procedure Cold: Ignition on/off to on Set compression release ? optional step even if saw is equipped with a compression release
Question about 160 CC Honda OHC Engine 21 in
...plug is wet the saw is flooded. Try the following to clear that condition. Extreme Flooding by Dolfoff; Please follow this link, http://www.fixya.com/support/t3226410 cursor down to ?Best Solution?, ...
Question about 450 e-series 18" Chain Saw
...http://www.husqvarna.com/us/homeowner/support/customer-support/ Start Procedure Cold: Ignition on/off to on. Set compression release ? optional step even if saw is equipped with a compression ...
Question about 450 e-series 18" Chain Saw
Chainsaw starts fine, but after it warms up and I turn it off it doesn't want to start back up. Seems to be flooded? Put in new plug and filter, and always has fresh gas. What can I do? You provide no
...Half choke should release as soon as you hit the trigger. Start Procedure Cold: Ignition on/off to on. Set compression release ? optional step even if saw is equipped with a compression ...
...pull starter, the engine will get going until the choke lever automatically begins moving to the OFF position and the engine should be running but the engine turn OFF after the choke move to OFF ...
Question about Chain Saw 20" Bar
...128ld starts and idles fast but only with the choke half on. Give it gas or take the choke off and it dies. My husqvarna 128ld starts and idles fast but only with the choke half on. Give it ...
...screw starts but chokes out when i give it more gas Have you checked the choke leaver is in the off position, if the choke is stuck on ant you rev it, it will choke out, could also be carbonized ...
Question about 12"" K760 Concrete Saw"
saw runs at normal idle with choke pulled and wide open with choke off saw just had new head piston ring and carb put on. it starts right up with choke...push choke in and ramps up to full throttle I ...
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions