OBD-II port You mean where is it located?? It should be under the steering, where your knees would touch the lowere part of the dash. Normally on the right, sometimes in the left.It's a rectangular ...
...obd II connector location? Under the dash on the drivers side and you have a OBD1 system on your 94 T&C. Here is a link that should be of help if your trying to retrieve your DTC codes. Thank you ...
Where is the onboard OBD II connector ? In the cab or under the hood. The OBD II Connector is located left of the steering column, at the bottom of dashboard just above the E-Brake Pedal.
...what does it mean Inspect the EVAP system for cuts or holes in the hoses (you may hear a vacuum noise or smell fuel), repair if any found. P1495 OBD-II Trouble Code Leak Detection Pump Solenoid ...
...to auto-zone and they will read for problem codes for free of charge. with an OBD-II scanner. to tell with area the problems in. good-day ! but check engine light has to stay on to read problem
OBD-II test Vehicle's`On-Board Computer system is not ready to be tested did you properly enter all the info correctly and make sure your DLC CONNECTOR is secured nicely?
...OBD-II Trouble Code P0300?http://schematicsdiagram.blogspot.com/2011/12/obd-ii-trouble-code-p0300.html-------------Getting diagnostic code ...
Question about 2005 Town & Country
Check engine light came on checked with OBD II and code 700 & 740 popped up Replace input and or output speed sensors located on the transmission
Check engine light is on Checked with OBD II and code 700 & 740 popped up. Is it the Transmissions Range Sensor, Speed Sensor or both? Replace and done
Where exactly is the OBD II connection? should be under the drivers side of the dash. You don't need to remove any panels.
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,079 Questions
746 Questions
666 Questions