...Number one is firing? Look at the distributor. If you have a distributor cap and rotor assembly remove the distributor cap and crank the engine. If the rotor turns check the rotor to make sure there ...
...line up with number one on the cap. Mark number one on the distributor with a marker. The cap is marked for number one. Put it all back together and the engine should fire up. Then time the ...
blow out of the hole) stop, look at which terminal on the distributor cap the rotor is pointing to, that wire goes to number one. Number one is the one closest to the belt end of the engine. Good luck
...number 1. Don't be afraid to take a picture of it before you start. Just because. Remove the distributor cap,and mark where the rotor button is pointing,exactly where it is pointing.Then mark the ...
...Number one on the distributor. Hope this helps. Please rate. 1995 Chevrolet K 1500 Suburban 4WD 5.7 liter V-8 VIN "K" 1995 Chevrolet K 1500 Suburban 4WD 7.4 liter V-8 VIN "N" Hope this help (remember ...
...distributor Number 1 is at the 5 o'clock position. The firing order is 1-8-4-3-6-5-7-2. The distributor turns clockwise. 18436572 Number 1 is front plug on drivers side. they go clockwise rotation on ...
...at the distributor cap and the corresponding numbers for the firing order are molded into it, you may need a flashlight to see them. They correspond with the numbers shown by in the above
Question about 1995-1997 Chevy 1500 Truck Ignition Starter Alarm Switch
...5.7 chevy 1995 pull your distributor out set your crankshaft to 0 degrees top dead center and install the distributor pointing to spark plug number one on distributor cap then try to start ...
Question about 1995 Mercedes-Benz SL500 5.0L Professional Preferred
order diagram distributor cap I need the correct wiring placement for the spark plug wires on the distributor caps WE need to know the engine size and the number of cylinders before we can answer that
number one spark wire in distributor cap if not you may have to turn the engine a little with your hand apply a paint mark on the edge of the distributor body directly below the rotor tip. also make a
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions