turn signal quit working ( bulbs did not light at all) I change the flasher, and they work fine. I found the flasher behind the ashtray. Of course I had to remove the ashtray. A funny thing about this
Question about 1989 Cutlass Supreme
...not turn on unless the brights are on and lever is held in place I just bought this car and it runs great but the turn signals will only turn on if I flip the switch in place and then pull it toward ...
not engaged. If I turn on the headlights or engage the brakes the turn signals will stop working. This does not happen all the time. There are other times where everything will work fine. Any thoughts
Question about 1993 Cutlass Supreme
...just stay lit and will not flash on and off. The turn signal shuts off properly at the end of a turn, it just does not flash. Could these two problems be related? you need to replace the flasher ...
...NOT WORKING WHEN USING TURN SIGNAL. 4. WHEN PUTTING ON THE HIGH BEAMS (or pulling the turn signal lever towards you) THE BRAKE LIGHTS/TURN SIGNALS WOULD WORK. (But the brake lights did not come on ...
...not turn signals OMG. Someone with a car older than my '87 toyota. Possibly a bad switch, but first locate your turn flasher, maybe that is bad, easier to try than another switch. Turns ...
Question about 1993 Cutlass Supreme
...turn key to start interior lights and all accezsaries go out and do not come back on. car will not crank over. giggled key in switch and turned ba kwadd Turned key backwards once and got radio and ...
Question about 1997 Cutlass Supreme
...not with turn signal..flasher replaced. is It the multifunction lever then?? There should be a turn signal flasher and a hazard flasher. They are two different parts. If you replaced the hazard ...
...not turn off I tried to turn the car off and it wouldn't shut off. I can turn it over but it won't turn off and the ignition switch his very loose sounds like you need a new switch but you can pull ...
... Make sure the steering wheel is not hard locked while turning the ignition. Try gently moving the steering wheel while trying to turn the ignition. Sometimes a spray of wd-40 in the cylinder will ...
Usually answered in minutes!
697 Questions
571 Questions
488 Questions
387 Questions
236 Questions