Question about DocuColor 12 Printer
...print on textweight paper, images start coming out on paper not fully (cooked) it starts to peel off after 40-50 impressions. Any ideas? Have you properly make setting for media attributes ? plain ...
Question about Phaser 7700 Laser Printer
print-quality in the margins of SRA3 paper is not guaranteed. 4. Inspect the Accumulator Belt cleaner; replace the cleaner, if necessary. 5. Run the Remove Print Smears routine. From the front panel?s
Question about Phaser 8560DN Laser Printer
...variation is normal, occasionally occurs, and usually self-corrects within a few printed pages. If a print-quality problem is not resolved with the information provided in the Diagnosing ...
...then restocking printed paper to print even pages?. I am afraid not. The printer doesn't have automatic duplex printing capacity. To print both sides you have to do it manually, as you are
Question about Phaser 8560MFP Laser Printer
...print head not allowing it to move properly. Your print head is stuck. Either the print head block has gotten ink in it and will not allow it to tilt, or the print head wiper is tacked, ( stuck) to ...
...message: 07,010.43:24426 The print head is not moving freely. The print head wiper may be tacked to the print head, or the print head block may be filled with ink causing the print head not to
...not print duplex. From print command window, I choose "Properties" and then "2-Sided Print" from the 2-Sided Printing drop-down and then OK. Yet, it printed on 2 pages and not front & back of one ...
...and green check the black cartridge, it may be out. If it is ok, print a test page to see it will print black. If it does not print black, there may be toner spill blocking the black toner
Question about Phaser 4500/B / Phaser 4500/YB Laser Printer
...not have a duplex unit and cannot print double sided printing automatically. DOUBLY SIDED PRINTING WITHOUT A DUPLEX UNIT Open your Word document. Open page 1 - then Print the current page. Then put ...
...routine does not clear the blockages, then print head needs replacing, but it may be expensive. It may be more cost effective to buy a later model and better printer than replace the print
Usually answered in minutes!
534 Questions
436 Questions
284 Questions
267 Questions
262 Questions