Questions & Answers for: HP ScanJet does not power on

...not in use for sometime. Then I pressed the on buttom and there was no power light at the machine. With no apparent power to the unit I check the power cord voltage and no response in the test meter. ...

...not share power well and pulls it in large amounts - when it can't get it it throws little power fits and sometimes will not turn on at all. Try another wall outlet and see if you can get it to power ...

...Power Module : Power module (wall mount type, Delta ADP-36XB Rev. B) - 100-120VAC, 50-60Hz input - 24VDC, 1.5A output - 3-prong connector, grounded - Detachable power cord not needed (USA,

power to hp 5470c scanjet. Have not used it for about 6 months. Now can get 0 power. Could it be the power adapter? Or is it in the machine? Have tried different electrical outlets and still no power.

not power up. I think the power My scanner will not power up. I think the power cord is bad. Any suggestions? Check the Connections in Most of the cases the Power Cable might be the Problem Check with

...power cord if not then what gives it power You need a power cord for this scanner. If you have lost the power cord, you will need to replace it. I'm not sure of the specs for this (whether HP uses a ...

power cord not needed (USA, Canada) - NOTE: Use a High Power AC Power Module if an Automatic Document Feeder (ADF) is attached European use , C8517-84201, Low power AC power module (Wall Mount Type) -

...not power up on the new brick, then the primary control board inside will need to be examined for a blown fuse or may be dead. If you are confident enough to open the scanner and check the fuse, ...

...not power up. I have not tried to use scanner lately and it has been broken for over a year. Wish to bring back to life with my windows 8 64 bit operating system. When I last considered fixing it I ...

...not getting enough power to heat up and function properly. Do you have the printer connected directly to a wall outlet or is it in a surge protector or power bar? Even if you have been using a surge ...