Questions & Answers for: Chrysler 300 does not power on

...power is not getting to the shifter lock from the brake light switch the car will not come out of park Try this. Start car press down hard on the brake pedal(as far as it will go and hold it. Now try ...

power windows will not roll down all four fuse blown or power switch not working. Check fuses & check wires to switch--if okay replace switch.

not start. no panel lights and no power on aircon,radio and romote key do not response. also lock system doesnt work thanks Thanks for choosing FixYa. Because you have no power at all, your problem is

...power to operate.these have a problem with cam sensors and crank sensors that go bad.if either sensor goes bad the car will not start.also keep in mind that even though a scan tool might show one of ...

...comes from the sensor at the thermostat. If only one terminal has power, then I would replace the thermostat sensor if not both. Hope this is clear as mud! and helps! Please let me know what you

fuses in the power distribution center (in the trunk?). The fuses are 36 and 40. There could have been a spontaneous failure of the power switch, i.e., it works mechanically but does not turn on power

...power at all even to the lights, horn, trunk release, etc. I checked the voltage at the battery. it fluctuated from 50-130 volts. looked really crazy. what could cause the battery voltage to read so ...

...again now I have power but won't start If is not cranking,check your starter motor if is get power. if no check that ignition again for loose connection, check relays. Or else your starter need ...

...not work again,all wire look good, 1st check all power supply and grounds to the motor when you apply a input from the switch,if you have power and ground to the motor it should work,apply a separate ...

...power window relay location window will not go up, replaced window motor and switch, still wont go up Is the window motor getting power at the motor? Is the ground OK? If it's only the driver window ...