Question about 2004 Sequoia
...engine compartment, thinking it might be a bad or wore waterpump, but need to know some signs or indications. Troublkeshoot possible noisy idler pulleys, if they are OK, remove the plastic cobers & ...
engine noisy checked code and found knock sensor bad. where is the knock sensor located on a 2002 kia reo. should this be chaged right away. engine noisy,used one of them sunday mechanics code readers
engine light on, noisy idling, short coolant-2001 JAG VDP N EW TO JAGUAR-ONE WEEK. ENGINE LIGHT ON PERMANENTLY. NOISY IDLING PROBABLY FROM ONE OF THE PULLEYS ON THE DRIVE BELT. COOLANT GREATLY REDUCED
noisy, wobbling pulley (between fan and engine) 4.9 litre 4 X 4, standard four speed xmission, pulley behind fan wobbling slightly and making a racket. Changed fan clutch; problem persists. No coolant
...noisy and the a ac doesn't work anyway. I would like to know if there is a serpentine belt that i can install and bypass the ac pump. depending on your engine then yes for example, if you have a 3.8l ...
...spring loaded automatic tensioner pulley, what is the problem? is it noisy? if so you have a problem with engine pulley alignment, the belt is worn out/stretched or the automatic tensioner is ...
...of the pulley on the compressor goes around it sounds like there is a very noisy rattle from the engine. It is OK when AC is not on. any ideas, and can this be fixed without replacing the
Question about 1998 Gs 400
...noisy in the morning when the engine is cold. What could be the problem here? Noisy idler pulley gs 400 lexus. More noisy in the morning when the engine is cold. Recently have the pulley replaced. ...
...engine warmed up Is this the accessory drive belt that is noisy? If so check the belt edge for frayed or exposed cords like a tire cord, if that is found you have a defective pulley Or a crank ...
Question about 1998 Gs 400
...noisy i suspected engine Valve. What could course this noisy can someone please help me Did you recheck the valve timing after fitting the new belt did you replace the idler and belt tension pulleys ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions