Questions & Answers for: new flame

...flame from all carryover tubes. This grill is brand new New grill model 463247009. I have yellow 2 -3 inch high flames coming from all carryover tubes between the burners. The heat setting does not ...

flame went up the vent. The charcoal filter was actually on fire for a few seconds. So now when I try to use the vent it makes a very loud sound. It runs but it is scary noisy. Any ideas or is it time

...new Flame sensor in and checked for continuity to ground (near zero) and still have the same problem. New Flame sensor is running at 1.3 micro amps while the old flame sensor was running at 2.7 micro ...

...new smeg gas cook top. flames burn with yellow top and carbon build up on pot. how to adjust air contence of flame. There has to be a small screw close to where the burners are located and all you ...

...furnace acts like flame sensor is bad, but will not code. Replaced flame sensor no change if flame sensor is new, the board may not be properly recieving currrent from flame sensor to keep burners ...

flame thrower when lit on bosch 125 blp Bought new pilot assembly and put on. Pilot blew like flame thrower. Took off and put old one back on which was working right before except was burned up on end

...new one from Fire Sense unit. Flame still goes out when I release the knob. When its burning is has a good flame. Whats my next option. The unit is in a screened porch never has been in rain. Alot of ...

...ignition my flame tarts to roll out causing melting of wireing Use is propane new flame igniter and flame sensor rod new burners new wire ...

...new Williams 25,000 BTU wall heater burning yellow flame I had an old wall heater that the gas company shut off because it had a yellow flame. We had it professionally cleaned, pilot light replaced, ...

flame kicks back on. Then everything runs again. Repeat. New filters, new blower motor and new inducer. Last season. I have the same problem. The vent flu. Is building up condensation and running back