Questions & Answers for: MAZDA3 negative camber

Unable to fuel up When trying to fill up, the gas pump keeps stopping acting like its full of fuel when I know it doesn't fill up on 1-2 gallons (I wish!). Acts as if the filler tube is not venting. ...

...the display flashes all through the characters, everything else is working fine I disconected the negative battery cabke and keft it off for about one hour. When it was reconnected the display ...

...connections at the opposite ends of the cables. The positive cable connects to the starter and the negative connects to the engine block. Make sure all connections are

...negative camber.....is it adjustable? The toe was out of adjustment........when adjusted to specs the camber was still -2.3 degrees Camber is the lean "off perpendicular" of the wheel. This error ...

...servicing the vehicle, refer to the precautions section. Remove the battery cover. Disconnect the negative battery cable. Remove the plug hole plate by lifting off and removing the plug hole plate ...

...2.3L MFI DOHC 4cyl Before servicing the vehicle, refer to the precautions section. Disconnect the negative battery cable. Drain and recycle the engine coolant. Remove the drive belt. Remove the ...

...to the regulator motor. there will be two contacts at the motor connector. reversing positive and negative changes rotation of the motor, raising or lowering the window. If the window rolls back up ...

Radio goes off when you go over a bump then comes back on You may have a loose positive or negative connection going to the stereo. I would say the likely source of the problem is the positive lead ...

...Under the Passenger SeatLeft Front Speaker Positive Wire (+): White/YellowLeft Front Speaker Negative Wire (-): Blue/GreenRight Front Speaker Positive Wire (+): Red/BlueRight Front Speaker ...

...be a short or a component is staying on. you need an amp meter and hook it up between your battery negative terminal and the negative battery cable.turn the key off and check how many amp is the ...