Questions & Answers for: needle valve kawasaki 125

125 kaw kx 2 stroke good power on low end power band strong on top end bike dies out from low to high in middle replaced piston blewout jets checked reed valves messed with carb tuning cleaned exsaust

Ad

Question about 2002 KDX 125

1 Answer

...needle valve. Even a spec of sand can cause this. Take it apart and clean or replace it. Get a new overflow hose on it as well (helps keep dirt out of the carb and directs excess fuel away from the ...

Ad

needle one notch lower. Two notches may be needed but start with one. A ?very helpful? rating for this answer? Thanks! does it have a power valve adjuster on the side of the cylinder if so you need to

...needle down one notch. This should take care of the problem. Best wishes. Remove your kips cover and rev the engine over 6000rpm and see if your power valve is working , as after a while they get ...

Question about 2001 KMX 125

2 Answers

...valve ( needle and seat ) stop the the fuel flow? can the fuel bypass the valve? On one occasion the crankcase was flooded ( full) of petrol, not a good thing,I suspect it flooded the carbs and then ...

Question about 2005 Wind 125

0 Answer

valve is not seated or leaking. 8. Restricted fuel supply tract. 9. Plugged bowl vent. 10. Loose or plugged fuel and air jets or passages. 11. Improper fuel level. 12. Worn or damaged needle or needle

Question about 2006 Wind 125

0 Answer

...6. Float needle is not seating. 7. Faulty reed valve. For more information about your question please visit the website below. Good luck and have a nice day. Manual Kawasaki Bajaj Wind 125 ...

Question about 2006 Wind 125

0 Answer

needle is not seating. 7. Faulty reed valve. For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful

...needle or ball bearing and or their cages. 3. Any internal metal components, clutch, oil pump, transmission, shifting parts, cylinder, rings, valves, springs, etc. 4. Any of the above will require a ...

Question about 2001 KMX 125

0 Answer

...needle is not seating. 8. Faulty reed valve. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66834 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...