plate The needle misses the hold where it should go through and hits metal one the throat plate. I fixed the sewing problem, it was a belt. if a new needle still wont align with the needle plate, your
Question about CS6000i Computerized Sewing Machine
...needle is hitting the lower looper, and therefore breaking. This is happening with both needles. I have taken the covers off and the needles are hitting the metal. Is it possible that the looper has ...
...capability allow you to adjust the position of your needle ? right, left, or center. If your needle is not positioned correctly, it may be hitting your needle plate or pressure foot. Hope this
...capability allow you to adjust the position of your needle ? right,left, or center. If your needle is not positioned correctly, it may be hitting your needle plate or pressure foot. I hope this
...needle hits, if you are in zig-zag mode and it is hitting the base plate(wide slotted base plate req'd) the machine may need re-setting of the needle stops(if fitted). This is uncommon so its more ...
...needle keeps hitting the throatplate, (I have broken 2). It was working fine. I don't know what I have done to cause this! e. Hello, First, check the position of your needle.Machines with zigzag ...
Question about 132QRFB Mechanical Sewing Machine
...needle is hitting the bobbin plate. Can't figure needle setting. The needle keeps hitting the bobbin plate. first change the needle--flat side to the back of the machine, make sure the needle ...
Question about 132QRFB Mechanical Sewing Machine
Needle hits the plate and bends. What would cause this? The machine seemed to work fine before, but now the needle hits the plate when sewing. I'm assuming something is causing the needle to ...
Question about 132QRFB Mechanical Sewing Machine
needle is hitting the sides of the needle plate where the needle goes through, then the needle is too wide for the plate. Either use a narrower twin needle or see is a needle plate with a wider needle
...the mount so that it is straight up and down. If the needle is still hitting the plate, the needle bar may be bent. That may be not be repairable even by a professional. I hope this helps. Cindy ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions