needle plate is gouged or signs that the needle is hitting the plate. If so, you may be pulling a little too hard when the fabric is feeding. Sometimes when you pull too hard, it pulls the needle back
needle hits the throat plate The needle misses the hold where it should go through and hits metal one the throat plate. I fixed the sewing problem, it was a belt. if a new needle still wont align with
Question about CS6000i Computerized Sewing Machine
...the needle and then using the side wheel wind through the stitch process manually. If the needle is still hitting something down under the needle plate, then your timing is out, take it to a
Question about XL-5500 Mechanical Sewing Machine
...of the base plate. Also turning dial to switch between positions 2 & 3, the needle doesn't move left to right. Is this a linkage problem ? Adjust the metal plate to fix the needle hitting
Question about LS-2125 Mechanical Sewing Machine
...the plate and breaking. How do I fix this? Take the needle plate off and see where it needle is connecting with the bobbin. The bobbin case may not be in place and this is what the needle is
Question about LS-1217 Mechanical Sewing Machine
needle continuously hits the face plate, or the foot and breaks. It is the correct needle, in the right way, same with needle position and foot position it sounds like the machine is out of time, &
...side when it comes back up. When I reverse it, the needle hits the metal under the bobbin. The needle and the hole do not match up. try changing needles also possible that the machine is out of ...
brother xr7700 needle hitting plate needle hitting left & rear area of plate sounds like the machine is out of time & needs to be serviced at a sewing machine repair shop
...needle hitting plate Replaced needle as thought it could be bent but no difference http://download.brother.com/welcome/doch000293/xl21202220om01en.pdf Sometimes that happens when I have the needle ...
Question about XR7700
...needle plate. BUT, it only hits when the front cover is on the machine. Ok so i needed to clean and oil the bearing and I did. Did not touch anything else in machine. put it all back together and it ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions