Questions & Answers for: needle bar on sewing machine stuck

...needle bar, if this is the case the chances are if you broke the needle there may be a piece stuck in the bobbib case area but can you be a bit more explicit. Thanks Ken ...

...needle bar has been pushed up and is out of adjustment. You need to take off the side cover, there should be a screw on the back of your machine holding it on. Remove this screw, and remove the ...

...NEEDLE BAR FIREST U WILL FOUND TOW SLASH ON NEEDL BAR THE HIGHST ONE FOR HIGH OF NEEDLE BAR BRING THE HANDWHEEL AT LOSET POINT DOWN AND LOSE THE SCREW FROM INSID AND MAKE THE NEEDLE BAR AT HIGH SLASH ...

bar that holds the needle looks bent. It moves freely up and down and side to side. When the needle comes down it is close to the left side of the pressure bar. After reading these tips, I'm wondering

...manually but the computer won't change positions based on the stitch I choose. How can I fix this When you turn the machine on does the needle bar initialize? I.e. Move to the left, then to

...needle bar is stuck down. I was able to get the needle out but cant move the bar it sits in. It is so low i cant even get another needle in. When i push the start sewing button it goes clank clank ...

...needle bar won't go down when any of the pictures are selected to sew, duck bear. The letters work and all the straight stitches and zigzags. Any ideas? Hi Karen, Looks like your machine is stuck in ...

needle bar is stuck in the down position. I was embroidering and all of a sudden the needle movement became sluggish and then stopped. Rebooted machine, removed embroidery hoop, needle, bobbin, thread

position, could have gotten stuck by accident, also put a piece of fabric under the needle and press on the foot pedal to make the machine "go". It should begin moving the needle bar and straighten up

...needle bar at its lowest point, open the bobbin cover. If you see a loop of thread, try and slide that loop until it clears. If there are several loops around the bobbin/bobbin case, you might try ...