Question about COMBINATION SINGLE POLE TOGGLE SWITCH
...two different switches that control one light and a single (pole) switch that only controls one light. you can't do that with the above switch. You need a combination 3-way and single pole
switch using 12-2 romex? Only if you have two separate 12/2 lines. You need 12/3 w ground, because this is needed to connect the two switches and carry the neutral. You can start with 12/2 power going
Question about R01-PR180-1LI Decora 180 Degree PIR Motion Switch Ivory
...need to install a IPP15-1L at the switch box that has the cable going to the light (load). One must then install a IPP0R-1L at the switch box that has the cable with hot from the breaker (line or ...
Question about 003-1755-W Three Rocker Switches
...switch plates we would like to put in are just 3 on/off switches, as some of the old ones shared light sources and we don't need this. We just want to hook up the wiring and be able to turn a light ...
Question about 1451-2ACP Grounded Quiet Switch
...switch in my bathroom. I need to replace the light switch in my bathroom. The faceplate is metal, and the switch doesn't show a grounding screw (leviton 01451-W). The replacement switch I found has a ...
Question about 1451-2ACP Grounded Quiet Switch
...switch in my bathroom. I need to replace the light switch in my bathroom. The faceplate is metal and the switch doesn't show a grounding screw (leviton 01451-W). The replacement switch I found has a ...
Question about 3W Lighted Toggle Switch - 1463-LHC - Clear
...switch to a lighted swich You need to pay attention to the dark colored screw. The wire that is attatched to that screw is called the common you will need to attatch to same screw on your new switch, ...
...on at one location, you need a single pole switch. Basically, you break the black wire with the switch. If you need more assistance than this, post a comment. Thanks for your interest in ...
...are inter changeable. If you really need a 3-way switch, be sure it is labeled as that on the box and look for 3 connections on the switch its self. Else, try a switch rated for a higher
Question about Decora Gray Rocker 4-Way AC Quiet Switch
...need a 2-wire coming from power source, 3-wire from first switch to 4-way switch then 3-wire to last switch. white wires (neutral) get connected together. Depending on the layout of the switches. i.e ...
Usually answered in minutes!
55 Questions
32 Questions
32 Questions
23 Questions
19 Questions