Question about 1998 XR 250 R
...250 Freshening up top end, need torque spec. you dont need torque specs on that just use a 1/2 inch drive with you 14mm or16mm socket hold the wratchet right at the top and tighten it as tight as you ...
250 head torque spec Auto Decompressor Bolt 104 in·lb Cylinder Head Cover Bolts 87 in·lb Cylinder Head Bolts: M10 36 S M6 104 in·lb S If he spelled the. Cylinder incorrectly and someone
...250 or will it need to be re-sleeved? Not sure if the cylinder sleeve is stock. My understanding is that Kawasaki installed factory sleeves starting in the mid 1980s, but not sure if all models were ...
...250 R cylinder head bolt torque specs How much torque does a cylinder bolt need for a 2002 honda cr250r? Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the ...
...250 can the cylinder be bored out, or do just replace with new. Yes the cylinder can be bored, BUT, it would be sent to a company in California for the work. The cylinder has a nickel plated surface ...
...head and the block Remove the cylinder head cover then tighten the four head bolts holding the head and cylinder to the gearbox. Hopefully you will not need to find and install a new cylinder
...250 ran perfect for the first year. Then lost power. you pull front plug wire off while running it dies instantly. pull rear wire off it still runs rough. if you leave wire close to plug you can here ...
250 Honda Hi, Anonymous for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you
Question about 2003 YZ 250
...need please click on the links below. Good luck and have a nice day. 1998 YZ 250 torque specs Yamaha 2 Stroke YZ125 Part 15 2 Stroke Installing Piston Rings Cylinder and Cylinder Head YAMAHA YZ250 LC ...
Question about 2005 Bruin 250
250 quad the side of my cylinder is starting to leak out oil on the outside. How can I fix this??? Should I re-torque the cylinder head??? You will need to replace the head gasket. Tightening the head
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions