I just picked up a1986 Ninja 1000.Sometimes it runs on all 4.But most of the time just 2I just checked and the right side coil has continuase power.What might cause such a thing? Please help Iv been ...
one coil wont fire the other is fine and it is new 1982 Kawasaki 1000 ltd try putting the working coil onto the side which isnt working if it then works then you need to replace the duff coil. if it ...
...does any one have any ideas? any help would be greatly appreciated. thank you the carbs need balancing. i have the same bike and mine was doing the same untill i got them balanced..
Hi does the gpz 900r have the same crankshaft as the gpz 1000 rx . Thanks No but there is not much between them if i remeber right the cam lobes are slightly bigger which would give you more air and ...
Hi Guys, what is the oil capacity for a Kawasaki GPz 1000 RX with an oil filter please (1987). Sorry I 've ordered a manual but it's still to arrive. Interestingly here in Australia, they recommend ...
i have a 1982 kawasaki 1000 air cooled bike. while i am ridin on the highway it just dies with no warning that i can tell. it has happens while being on the highway for as little as 10 min and as long
I can't get any spark plug socket to fit my 1986 ninja 1000? You can get them on ebay for a fiver, long reach, 18mm/16mm. Got one recently
i need the specs for setting the floats and jets on a 1986 kawasaki gpz 1000 The float setting is 17mm frombase of carb to farthest edge of float ,holding carb vertical
what are the valve clearances on a 1986 kaw. gpz 1000 0.13-0.18mm inlet 0.18-0.23mm ex
gpz 1000 not cranking! what could it be? Only a few reasons.. if engine not turning over at all its seized motor, it could be a bent valve and stopping the piston from completing its full stroke. or a
Usually answered in minutes!
43 Questions
18 Questions
