Multi-pin connector (black) for lighting switch terminal 56 and dip and flasher switch terminal 56b (carburettor models) or multi-pin connector (grey) for dual tone horn (injection models) M Multi-pin
...Multi-Function Switch Removal WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR AIR BAG DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE ...
...switch is the multi function switch.To change this does require some special tools and some knowledge of the air bag system. If this information is useful please rate the information as it is useful. ...
...multi function switch on my 2004 optima kia...any demonstration/illustrations will be appreciated Kia_Sephia_Rio_Spectra_Optima_1998-2006 Multi-Function Switch - Removal & Installation Disconnect ...
multi-function switch water shield and bracket to the top of the steering column. Remove the one screw located below the left multi-function switch control stalk that secures the multi-function switch
...switch: Multi-Function Switch Removal & Installation 1. Open the hood. 2. Disconnect and isolate the battery negative cable. 3. Remove both upper and lower steering column shrouds. 4. Disconnect ...
Question about 2001 PT Cruiser
...(ECM)/Powertrain control module (PCM)/Transmission control module. Possible Solutions: Check Wiring/Connectors from/to Multi-Function Switch. Check Multi-Function Switch. Check Measuring Value
Question about 2001 PT Cruiser
...multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen. Refer to "Changing the function settings (when the ignition switch is "ON")". 2. ...
...multi-function switch. The right multi-function switch is hard wired to the left multi-function switch/Steering Control Module (SCM), which communicates with the ElectroMechanical Instrument Cluster ...
Question about 2006 Outlander
...multi-information meter switch for about 2 seconds or more to switch from the setting mode screen to the menu screen. Refer to “Changing the function settings (when the ignition switch is “ON”)”. 2. ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions