Questions & Answers for: mtx thunder bass

mtx 5000 thunder series subs along with a 1000 watt d series mtx amp. the subs are going wild . they bump the loudest bass ever the only problem is that they are doing it constantly, with no tune what

...mtx thunder 5601 class d, mono-block amplifier. The left and right a/c jacks are wired to a high to low level hl15 profile converter,then to the tweeters.Everything else in the stero sytem works ...

...mtx thunder 801d I am guessing the bass control is just a potentiometer that you plug in. It could be open and that is why the bass dies. As far as the switch goes, I am not familiar with the amp but ...

...mtx 15 5500 sub woofer dual voice coil any one know i have tried several ways there are several ways, it all depends on the bass response you want, and with that, it also changes the ohms in the amp. ...

mtx 801d amp turns on but no bass just high pitch sound sub is fine if theres a switch on ur amp that says LPF Full or HPF put it on LPF for low pass frequencies

MTX Thunder 3401 not responding. Lit but no sound. Hi I have the following installation : Pioneer Avic X3BT head unit/GPS Pioneer CDP 620 cd Changer Ipod cable MTX Thunder 3401 amplifier MB Quart 284 ...

...are talking about is an External Bass Control also known as EBC knob you can probably find one at MTX.com or crutchfield.com or any authorized MTX dealer. Please vote and leave high marks. Thank ...

...mtx 1000xd will turn on but makes a sound inside near the circle donut looking with(lots of wires soldered) and where my ground is to the trunk bolt and even in side speakers. It will not power my ...

mtx thunder 5604 and when the bass hits the speakers flex all the way out then thell go and flex all the way back in and thell do that,with the bass down lose grounding in the connector of your signal

lookin for a bass knob look on amazon or ebay but i would personally use amazon