Questions & Answers for: Yamaha XVS 1100 Dragstar motorcycle rectifier test

...rectifier failed and need to be replaced.In this case measure your generator coils too. sounds like you may have a faulty kill switch Bisides, to disconnect the cables that come from the generator, ...

Starter does not turn 99 Virago 1100 XV. Starter does not turn. I have been using the bike every day without problems. I came hoem Thrusday, parked it, everything was fine. Fruiday morning ... it ...

no head light. Headlight does not come on. checked fuses, changed light bulb. changed controls. need to test wiring to headlamp, would imagine if you don't have low or high beam condition maybe in the

...test and check cables with an ohmmeter if necessary. 4. Loose connection at ignition coil or plug between ignition sensor and module. 5. Spark plug cables in bad condition, shorting/leaking, spark ...

STARTING PROBLEMS XVS DRAGSTAR 1100 I HAVE CHECKED THE BATTERY AND THERE IS A GOOD LEVEL OF VOLTAGE, 13.4V IT IS STRUGGLING TO TURN THE ENGINE OVER AND IT IS AS IF THE BATTERY IS LOW, AS THE IGNITION ...

rectifier/regulator, cleaned carbs, cleaned gas tank, the bike is only firing on the front cylinder. There is a brown wire with black trace, bullet connection - believe it's to the carb heater

starter switch when push the button nothing happens Hi, Anonymous and the usual suspects are: 1. Ignition Switch not in the "ON" position. 2. Engine Run Switch in the "OFF" position. 3. Discharged ...

one cylinder not firing Hi, Anonymous and the usual suspects are: 1. Fouled spark plugs. 2. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test ...

I changed the stator and rectifier on my 2001 Yamaha vstar 1100 drove it for about 1 hour and the main fuse blew and the rectifier burnt up . Any ideas on where to look Hi, Shawn sounds like you have ...

1999 Yamaha XVS 1100 Custom. rectifier blew out. Need rectifier and wiring harness as the connection melted at the rectifier connection. Harness is discontinued by mfg. Hi, Rick you may have to ...