...Test: Start motorcycle, measure DC volts across the battery terminals you should have a reading of approximately 13.2-15 DC Volts. 3. Connections and wires: Inspect the regulator stator plug, and ...
...rectifier. This could be causing all the problems mentioned. To test it - remove from bike > Multi-Meter set at R x 1K > one will be for the> Battery Check for <2 way> open Diode here. ...
what is a rectifier The output of your alternator is A/C. For iy to keep the battery charged it must be D/C.The rectifier converts A/C to D/C. A rectifier convert electricity from one form to another ...
How do I test for spark on 150cc jonway It does not want to start. Can't get spark on sparkplugs Simple my friend and fellow biker. Remove the plug from the cylinder head, attach the plug lead again ...
...test the rectifier on the jonway 150cc. I have connected the battery and tried to start it but there is no start It's not the rectifier which is the problem as this is part of the charging system. If ...
Where can I get an electrical schematic for a Jonway Valero 150cc Hi Anonymous, for this situation I would call my local dealer or reputable shop's service/parts department and inquire about any ...
Question about Jonway Motorcycles
have a brand new jonway 50cc 15 miles blew bulb whats wrong put new bulb in rode it bulb went out Occasionally bulbs will fail for no reason. Replace the bulb and try again. If it fails again, then ...
Question about Jonway Motorcycles
...rectifier which would be covered under warranty take your scooter back to the dealer and have them fix it also ask them to take your scooter for a test ride to confirm the problem is resolved. Good ...
...test a voltage regulator. 5. Unplug the connector to the alternator and hook your multimeter leads to the alternator (pin/socket selection does not matter) set the multimeter to AC volts, at an idle ...
Question about Jonway Motorcycles
...Test: Start motorcycle, Measure DC Volts across the battery terminals you should have a reading of approximately 13.2-15 DC Volts. 3. Check Connections/Wires: Inspect the regulator/stator plug, and ...
Usually answered in minutes!