...3 - Grid Voltage error - Charger Roller Current Leak. In English: I would check the roller motor for a short, frayed, or damaged wires. Use a voltometer and compare the voltage to the cleaner
...voltage error) E100 Laser BD error E110 Polygon motor rotation error E202 No. 1 mirror base HP detecting error E204 ADF image leading edge signal detection fault (absent) E220 Lamp ON error E225 ...
...GND (-), it should be +5 VDC is measured. Try measuring the voltage between the Drum Motor. If there is no voltage detected then you'll need to replace Drum Motor (PL 1.1). Hope this helps... ...
...measure the voltage input motor, if there are the motor need repair4) measure the output voltage board, for input voltage motor, if there are NOT the board is faulty.see the block diagram.God bless ...
...test the input voltage motor, if there are the motor need repair.4) test the output voltage board, for input voltage motor, if there are NOT the board is faulty. see the block.God bless ...
Question about Tx5.0 Tx 5.0 Rc Treadmill Motor Speed Controller Board Fh-3545c-pw-n
...a) test the input voltage motor, if there are the motor need repair. b) test the output voltage board, for input voltage motor, if there are NOT the board is faulty., see the block diagram+ ...
Question about Tx5.0 Tx 5.0 Rc Treadmill Motor Speed Controller Board Fh-3545c-pw-n
...voltage motor, if there are the motor need repAIR, see my personal TIPSO for motor help 3) test the ouput voltage board, for input voltage motor, if there are NOT the board is faulty. God bless ...
...that reason measre the input voltage to the motor, and measure output the voltage motor from main control if there are NOT voltage the moto control is faultty.see the block diagram.God bless ...
...voltage) E100 BD interval error E110 scanner motor error E191 communication error for high voltage power supply E202 CIS home position detection error E225 CIS light intensity error E227 reader unit ...
...voltage D: replace the motor wire or change motor 4)E04 Incline Motor communication error A: Check the wire from incline motor to controller B: Replace the incline motor C: Replace the ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions