Questions & Answers for: motor stuck

...motor stuck forward Switch sometimes stuck forward and would run till battery dead. Now the motor wont go, stuck forward, suspect motor burned up since battery fine. Is it same motor for up and down ...

Ad

Question about PowerShot S2 IS Digital Camera

2 Answers

...stuck-shutter.html I have the exact same problem, took it completely apart removed the zoom motor, physically turned the zoom gear and retracted the lens, reinstalled the motor, put it all back ...

Ad

Question about 2001 Town & Country

1 Answer

...blower motor blower motor stuck on high! 2001 town &country 3.8 lxi. unpluged blower control module and blower motor still stuck on high. any ideas? thanks danny ce the resister for blower

stuck. remove knuckle? the entire ubnit is now hanging from the shaft going to motor/drivetrain. what now? ?????????????????????????????????????????????????????????????????????????????????????????????

...?Open or short circuit in wire harness. ?Defective throttle servo motor (potentiometer circuit). ?Stuck throttle servo motor (mechanism). ?Stuck throttle servo motor (motor). ?Malfunction in

...until new motor could be installed. Low humm as in motor is stuck and cannot turn would require removing belt and see if motor is stuck, drum is stuck or something in exhaust fan holding it back. ...

thats why it stuck. Then motor finally died completely. Check for power & ground to motor first, with ignition on & wiper switch on. If power & ground to motor, time to replace wiper motor

...or cable connections to it and try operating it by hand. If it is stuck, then replace it.If not stuck, then check motor operation (if climate control model) or cable routing (if manual

...motor or something is stuck in the blower wheel,try this,open the door,push in the door switch and with your other hand spin the drum as someone else pushes in the start button,sometimes this helps ...

Question about 2008 YZF-R6

1 Answer

...stuck in the motor, making it unusable. Is there any way to take apart the motor assembly further or is the string just stuck in there for good? the question is how did the string get past the filter ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29490 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...