Questions & Answers for: GMC Yukon motor cover

...sometimes cranks back up about ten min later with no problems I had the same problem with my 97 yukon. Replaced the Crankshaft Position Sensor on the front of the motor near the timing chain

...by recall warranty There are no gears in the speedometer. The gauges are driven by small "stepper motors" which are soldered onto a pcb. The stepper motors are a known issue at GM. If your vehicle ...

...need to remove the rear door cover and probe the wiper motor wires with a test light,with the switch on to check for power.if you have power replace motor, if no power check the wiper relay and ...

...cover is flexible enough that you can bend it down and get access to the motor once you get the other screws out. The motor is the big round thing on the right, mounted to the bottom of the HVAC box. ...

need to change heating fan motor in front. its making a loud whining noise. under rt side of dash behind lower dash cover 7 mm screws and u need a 1/4 inch drive with a universal

...motor and cover. Install the kick panel trim. Install the powertrain control module and tray. Install the floor air outlet. Add coolant to the cooling system. Connect the negative battery cable. ...

...ECM, as necessary. Electrical connectors from blower motor, as necessary. Bolt from right lower I/P support. Blower motor cover. Blower motor cooling tube. Blower motor flange screws. Blower

...cover off you'll see the resistor assembly right next to the blower motor just above where the passengers feet would be. It's about the size of a pack of cigarettes. You'll want to splice in a new ...

cover over blower motor, remove tube, remove electrical connector and 5 bolts retaining blower motor. Insert new one if comes with new cage. If not carefully pry off old retainer and reinstall cage to

...blower motor where is it in my truck It is located under the passenger side of the dash. You will also have to remove the glove box to access to screws holding the top of the blower motor