Questions & Answers for: GMC Jimmy motor cover

motor. Car runs good until you get to operating temperature and then the vehicle shuts down. Have changed coil, module, fuel pump, crank shaft sersor, new egr valve. Gives no engine codes. In side the

...Sounds like the blower resistor. It will either be located in the engine compartment outside the motor or inside the vehicle inside the blower motor cover. It could also as well be selector ...

...motor, should be a timing tab on timing chain cover, pull no1 plug out, hold finger on the spark plug hole or put a rag in the hole just enough to get it to blow out, bump motor over a little at a ...

...cover. Then install the distributor completely into the motor and make sure that the rotor lines up exactly with the "6" on the distributor housing. You may need to use a long screw driver to line up ...

...motor and wiper transmission have to be accessed. usually by removing a cover or cowl panel. purchasing a repair manual will help greatly in understanding the procedure. it will give clear instuction ...

...motor access cover screws. CAUTION Do not cut any deeper than necessary in order to remove the access cover. Cut through the access cover on the cut line using a sharp utility knife. Disconnect the ...

...motor down behind the plastic cover. it might get a little tricky getting those bolts/screws out but it can be done. you will also have to take the computerthingy and water tank in front of it for ...

...motor and remove that cover. then there are small screws holding the fan in that you need to remove then you can pull the old motor out and transfer the wheel to your new motor and reinstall. here a ...

...motor needs to be replaced. where is it and how can i get to it? MARK THE POSITIONS OF THE WIPER ARM ON THE LIFT GATE GLASS,THEN REMOVE WIPER ARM COVER AND NUT AT THE OUT SIDE LIFT GATE, THEN THE ...

...motor bolts in you simply put every thing back together the same you took it apart. I hope this helps you out and good luck. u have to remove the inside door cover and u have to brake the screws with ...