Questions & Answers for: Dodge Grand Caravan motor cover

Question about 2001 Grand Caravan

2 Answers

motor went out The fuse and relay center is located under the hood to the right of the battery.Pry off the cover with a screw driver and you will find a diagrahm of the variousfuses and relays on

Ad

Question about 1996 Grand Caravan

1 Answer

...1.5 inches distance from the cowl cover and the upper arm approximately 2.5 inches from the lower arm. Operate the wiper motor and check that the wiper motor parks when the wiper switch is

Ad

...motor on the hoist in front of you. The vin number is on the block somewhere,usually on the left side by the valve cover,look good,because it could be covered in dirt,or grease.take the vin down to a ...

motor on a 1997 Dodge Grand Caravan? Remove the cover plate on the passenger side of the heater box, 3-4 screws. Unplug the motor assembly, remove 3-4 more screws that hold the motor in place and pull

Question about 2005 Grand Caravan

2 Answers

cover to gain acsess to the motor. When kucky, I have had them work ok for another year before quiting again. turn the power on go over to passenger side remove blower motor plug test for power with a

...motor cover Remove the A/C-heater blower motor cover. Disconnect the blower motor wiring connector. Remove the blower motor wiring grommet and feed the wiring through the blower motor housing. Remove ...

...cover to the arm. Lift the arm cap up to expose the nut. Remove the wiper arm mounting nut. Using a suitable two jaw puller, remove the wiper arm from the wiper pivot. To Install: Verify that the ...

Question about 2002 Grand Caravan

1 Answer

...motor cover Remove the A/C-heater blower motor cover. Disconnect the blower motor wiring connector. Remove the blower motor wiring grommet and feed the wiring through the blower motor housing. Remove ...

I have a 2000 caravan with a heater motor thats intermittent . If I bang on the motor cover it starts working. Have you heard of this before? Yes and you need to replace the motor it has carboned up

...motor cover.Disconnect the blower motor wiring connector.Remove the blower motor wiring grommet and feed the wiring through the blower motor housing.Remove the blower motor mounting screws.Allow the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...