...motor. three torx screws. remove torx. care full not to bend prongs when pulling board. replace with new screws and cover and board. seal new cover with silicon rtv so forth to re prevent moisture. ...
...motor. Remove the cover held on by three screws. Remove the cover. The cover is the module. Should you need further help please just ask. Please rate the answer. This way I know the information was ...
motor. Maybe a bad connections or the bloer moter is bad No. do not cut the fiberglass housing.If there is a rubber cover then there should be an outline of where you need to cut but I don`t think you
...cover, and the plug in. Depending on where you buy the new blower motor, some come with the fan attached or you'll just have to switch the fan from the old motor to the new motor & just put it ...
...side(passenger) near the hood hinge. It is under the black plastic cover that you need to cut out to replace the motor. Follow the lines that they made in the plastic with a sharp razor knife.
where is the pcv valve? i can't see is a motor 2.2 where is the pcv valve? i can't see is a motor 2.2 liters I would assume its on the valve cover...my 2 c..
...The blower motor is under the hood, mounted in the firewall just inside the passenger fender. It will have a cover over it which will have to be cut and removed in order to service the blower
...valve cover gasket but i could be wrong. Any adive on where to start. THank you for your time. check behind valve cover while motor running, it will be smoking pretty good right where valve cover ...
Question about 1994 S-10
...out , and take the motor cover out and you will found 3 thing broken in said , replace it . let me know
Question about 2000 S-10
motor? It does two things, it kicks out the starter drive gear and spins. The flywheel usually has cover, remove the cover, try to see if starter drive gear engages the flywheel teeth, with key in the
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions