belt cleaning shift clutch ? Defective drum peripheral component motor ? Defective I/O control board ? Defective main control board 1. Pull out and re-insert the image transfer belt unit. 2. Clean the
...belt contact motor ? Disconnected connector of transfer belt contact sensor or motor ? Disconnected cable 1. Replace the transfer belt contact sensor. 2. Replace the transfer belt contact ...
...reseat the transfer belt, and try again. If the problem persists, clean or replace sensors, replace the belt, or replace the motor. Check the contact and release mechanism on the transfer
motor/drive, Transfer belt contact clutch if defective, Transfer belt position sensor if defective. or your Photo sonductor drum/PCU carriage unit does not turn or stock up or not inserted properly. I
...motor ? Image transfer belt out of position ? Belt mark blurred or absent I would remove the pcu unit (3 screws)and check the transfer assy belt mark and clean the sensor that reads the belt mark. ...
...blown fuse FU5 â?¢ Main motor/drive malfunction â?¢ Transfer belt contact clutch defective â?¢ Transfer belt position sensor defective â?¢ Harness ...
...and the lock signal is detected. → The belt mark sensor signal does not change for 120 milliseconds. ? Defective main motor ? Image transfer belt out of position ? Belt mark blurred or ...
...is detected. → The belt mark sensor signal does not change for 120 milliseconds. possible causes ? Defective main motor ? Image transfer belt out of position ? Belt mark blurred or ...
Question about Intermediate Transfer Belt Unit for Ricoh Aficio SP C811DN Color Laser Printers(sold individuall)
...SP C811DN? This is a ITB contact motor error. Check/clean/replace contact sensor. Replace transfer belt contact motor. Check harness and connectors to motor and sensor. Check for mechanical
Question about Intermediate Transfer Belt Unit for Ricoh Aficio SP C811DN Color Laser Printers(sold individuall)
...> brand=Ricoh > code=SC446 Code: SC446 ; Description: Transfer Belt Drive Motor ; Causes: The transfer belt drive motor failed to start within the prescribed time or failed during normal
Usually answered in minutes!
629 Questions
382 Questions
267 Questions
215 Questions
218 Questions