Question about S200 TREADMILL Drive Motor
...motor wont run the belt[ the belt dont move] the motor ron when i hook it up to a power drill so i no the motor works [[[ when i check out the AMPS coming out to the motor LG4 & LG3 just with the ...
...belt. If the motor and drive system are healthy, you should have a reading in the 2-3 amp range. Then walk on the treadmill at the same speed. With a person of average size (around 200 lbs.) you ...
Question about S600 Treadmill Motor Control Board : 152004
...motor hood cover and check the drive belt. If it is worn then you will need to replace that. You can purchase either of these products from the manufacturer, at www.iconservice.com. a couple of other ...
...belt on the motor either needs to be tightened or replaced. best way to find out is to take off the front cover showing the motor and step on the treadmill. if the belt isnt moving but the motor is ...
...belt and motor are fine then its the running belt that needs to be tightened, to check this just put your hand under the belt and try lifting it, if you can easily lift its 2 0r 3 inches then its ok, ...
...belt from the motor to the drive pulley of the treadmill belt. Does this sound reasonable or are they missing something big. This treadmill while older does not have that many miles, and want to put ...
...sensor alignment with magnet on pulley but still not working. Reset button is ok. Model R65 is the motor turning if so and belt slips or will not move when you put on weight its the motor belt. ...
Question about R65 Treadmill
...drive belt and replace4) Test the motor input voltage, if there are the motor need repair.5) test the output voltage board, for input voltage motor, if there are not the board is faulty.God bless ...
...belt motor 4) Test the input voltage motor, if there are the motor need repair, see my personal TIPS for troubleshooting HELP. 5) Test the output voltage board, for input voltage motor, if there are ...
...motor belt is not slipping when you use the treadmill. If it is not slipping turn the rear roller adjusting bolt 3/4 of a turn clockwise. Retest. If you have to turn it much more than another 1/2 a ...
Usually answered in minutes!
36 Questions
38 Questions
9 Questions