Questions & Answers for: moens hot water anti scald

...hot water in any position. The best I get is luke warm. I completely removed the nylon anti-scald ring and still the same. I pulled the center of the valve and flushed it. I do get equal amounts of ...

hot water if there's a sudden demand for cold water, i.e. a toilet flush, washing machine filling, etc. Fortunately Moen stands behind their products and will provide a new cartridge. Contact Moen and

...hot water faucets in the house work fine. What gives? Poltergeist? check ur anti-scold setting when shipped from factory unit is set cold install instructions always advise about adjusting to suit ...

hot water from the shower. i have a new hot water heater which was checked. i get hot water in the sink and the kitchen, but the shower water was 8-10 degrees cooler. i took off the safety stop so the

...hot water ratio. The anti scald is just a limiter on the rotation and you can remove this, if the water still doesn't get hot enough you need to replace the cartridge Turn the cold water feed down as ...

hot , the water is only tepid. I think the anti scald feature is letting too much cold water pass. Please advise there is a splined adjustment just under the handle of the 3175. you need to remove the

hot enough water. hat could be the problem? The anti-scald device behind the handle is improperly set. It's the (usually) black ring with 'teeth' on the inside. You obviously misaligned it when during

...hot, the water pressure drops. There is more cold water than hot. I have changed my moen valve before and this still happens. Good water any where else in the house including the master bath shower. ...

water no hot water Moen cartridges require a Moen puller tool. Your local hardware store will carry this. You may not be getting hot water because there's a safety tab located on the cartridge that is

...hot water side. Check for a ring or a pin under the handle that can be set in different positions. It will need to be moved clockwise to allow the handle to rotate farther to hot. Hope that helps. If ...