Questions & Answers for: Cadillac mod function

starts runs rich may stall several codes when vehicle came in i was able to communicate with mod.is now i cant.it will start up run rich for a few minutes and shut off. checked power at com.puter and ...

Main blower not working. Was working sometimes. Could it be the power mod or is it the main climate contror. Tried a class 2 scan tool and it displayed Climate Control. How can I test the main ...

...function of your car. There is no relay in the system. ? Heated Seat Switch ? Heated Seat Module ? Seat Cushion Heater Element ? Seat Back Heater Element ? Temperature Sensor ? Climate Control Panel ...

what is the fuel pressure on a 1991 cadillac deville Below are the specs from MOD. With the ignition key on and engine off, the system fuel pressure at the pressure test connection should be 46-59 PSI

...or not at all. It will go from low blow to high to nothing, with air or heat running. Temp contol mod. or relay? could be the power control relay but I think it's the electrical plug connectors ...

Cranks fine but will not fire. Has been down for several weeks due to head bolt mod. Car has been down for heab bolt mod. Got everything back together. cranks just fine but will not fire. Seems to be ...

...MOD fuse located in the body control module (BCM) fuse block that supplies voltage to the seat adjuster switch and the memory function switch, also supplies voltage to the MSM. The MSM monitors this ...

...an ground for those systems . Also read factory service information on how they work . Electronic modules involved . DDM - driver door module . If this vehicle came to my shop , first thing I do , ...

Hope this helps you. The following components are used to control the power windows: • Driver door module (DDM) • Passenger front door module (PDM) • LH rear door module (LRDM) • RH rear door module

...pin C- Brown wire pin B should be ignition hot on connector C1 on the Driver Climate Control Seat Module located under the driver seat. If you have power and ground, you may need to use a scan tool ...