...also the moduel could be worn out. its located on the front of the distributor and it takes a 5.5 mm socket but you have to buy a speacial socket at your parts store. good luck with it i have to
need to change the ecm on a 1988 ford f 150 5.0 what kind of bolts hold it on two 7/16 nuts on studs retain it. They are 10 mm bolts
how do i loosen the tensioner on a 1997 f-150 4.2 v6. What tools are required. I think it is a 15 mm bolt on the tensioner. Pull up on the tensioner to remove belt.
...the cv shaft is not as much work as it looks. Take the wheel off, take the axle nut (36 mm) off, undo the lower ball joint (21 mm) and then undo the 6 bolts on the inboard side of the ...
thermosta replacment on a f150 1999 remove 2 10 mm bolts remove o ring then thermostat . replacement is reverse. replace o ring.
...and mark the position of the rotor to the distributor. Unplug the distributor and remove the 13 mm holddown bolt and holddown and pull out the distributor. Reinstall lining everything up on the ...
have 1997 Ford 150 xl ,how do i change coil pock on #2 cyclinder.it is showing it is misfiring.? on passenger side 2nd one from the front should need a 7 or 8 mm. socket .
...on the mirror,but first disconnect the power wire that go to the mirror and then take them 3 10 MM bolts out and you will have the mirror in your
mm (Inch) 0.020-0.069 (0.00078-0.00272) Valve Stem to Guide Clearanceâ?"Exhaust mm (Inch) 0.045-0.095 (0.0018-0.0037) Valve Head Diameterâ?"Intake mm (Inch) 44.5- (1.75) Valve Head Diameter&
...I seem to recall it is a left hand thread. They make tools for removal. The wrench I think is a 32 mm open end looking wrench and the part to hold the water pump is a spanner wrench that is hooked ...
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,160 Questions
1,038 Questions