Questions & Answers for: mixer fuse blown

...mixer light action with input but no output to speaker no blown tops on transistors or ic no obvious burnt resistors or diodes no obvious short on transistors or diodes without schematic hate to go ...

...the mixer as the fuse will be inside the mixer on a circuit board (look around inside where the effects part of the mixer is) replace it with an identically rated working fuse and you should be

...mixer into and 220 socket. Is there a fix for this? assuming that its meant for a 110 outlet then you may want to check the internal fuse the high volatge would have blown the fuse before doing any ...

...to use in the UK. At once the mixer blew the main fuse box? Can my mixer be reapired? Distraught Barrie Perhaps you may be lucky to have blown a protection diode within the circuit seek pro ...

...fuse in PMP3000. The mixer went out on us one day, so I hooked it into an amp that we had. It works good as an unpowered mixer, but cannot get it to work as a powered mixer. I am assuming a fuse is ...

mixer blew a fusework Any unit that blows fuses needs to be serviced. Do not keep putting in fuses only for them to be blown again. Each time you put in a fuse and it blows, it will create more damage

...mixer The only fuse in that device is on the power input. If the fuse is blown, the mixer wouldn't power up at all - no lights, no signal, no nothing. It would be the same as if it's switched

...mixer but I suspect a blown internal fuse. With the power disconnected, open it up and replace the fuse with the original size. Put it back together with a couple of screws and power it up. If it ...

...of the mixer, and all I got was a sealed black unit that says 6A fuse? Is the whole unit the fuse, or is the fuse inside the box. If so how do I get it open? What kind of mixer are you working

...a repair manual for a proFX 12 mixer fuse blown and replaced but blown again some damage to surrounding components Go to the link below. Good Luck, Pops ...