...run really rough. If you do remove the clip, you will get a check engine light that denotes the missing signal from the corresponding injector. Make sure you don't do it on the #1 cylinder ...
...miss firing--2001 jeep g.c. larado I'VE ALREADY CHANGED THE SPARK PLUGS--BUT IT STILL COME UP WITH THE CODE FOR # 3 CYLINDER MISS FIRING, WHATS THE NEXT.... PLEASE HELP.....JEEP GRAND CHEROKEE LARADO ...
...miss firing, jolting, and not burning all of the gas. I replaced several relays, the battery cables and the engine computer. I made sure the battery was fully charged before installing the computer ...
...4.0... runs fine... after shut off (5-10 mins) acts like its chokeing out, wont start acts like its missing, no combustion (fuel injected) let sit for 20 mins, fires up fine... good plugs wires, cap ...
...miss firing. The vehicle runs good at 45 mph and above but when I come to a hill or red light it sputters and misses. do a compression check on the engine, and replace the bad sensor, i take the ...
...matched # 1 on the block to #1 on the distributer cap etc .. turns over but not fireing ,what am i missing ?? ty if that distributor has ever been out, it may not line up on #1. check to make sure ...
...sounds like it is out of time when it fails to start. When it does start, it sounds great. Sounds like a leak in pump switch and miss fire on 1 and 6 could be do to this and or injector on 1 and ...
Usually answered in minutes!
1,380 Questions
1,162 Questions
698 Questions
672 Questions
659 Questions