miss is present but goes away as soon as you increse the rpm's You are mis fireing on cyl 1 and 3 if you replaced plugs and wires and coil this is going to be a fuel injector issue or valve issue. See
...new one again and still had no luck. it was running before Is you firing order correct ? and rotor seated 1-4-2-5-3-6 3.0 and 3.8 are the same The cap should be marked #1 firing order is ...
...miss fireing. I have replaced the wires and the plugs. Iwas told that it is probably a valve that went bad. Can you still drive with it in this condition? its not recommended to drive a vehicle with ...
miss while idling. I have checked for leaks but can't find any, vacuum hoses are ok. I am getting codes: P0171 and P0302 Pulling Spark Plug on # 2 looks black and caked up with carbon, I have replaced
...of holder 6 inches check engine light flashing is a miss fire most of the time that may be bad plugs or plug wires that would also explain lack of power don't think it has anything to do with dip ...
ford has miss fired in #6 i put new plugs and new coil pack the plug lead may be faulty replace & see if it solves the problem......hope this helps.....cheers
...miss firing MISFIRING MEANS PLUGS NOT FIRING WHEN IT SUPPOSE TO.IF SPARK PLUGS HAVE OVER 100000 MILES ON THEM TIME FOR NEW PLUGS AND WIRES.IF ALL IS GOOD. A BAD COIL OR DIRTY FUEL INJECTORS TO BOTH ...
cylinder 3 and 6 are miss firing. What does that mean? if 3 and six are missing then replace the ignition coil
miss fireing then all goes away. Runs fine all day or atleast till you let it sit 6 hours. Scratching my head on this one. Looking at next IAC valve cleaning, new fuel filter, and a coil ohm test just
i have miss fires on cylinders 5 and 6 on my 2000 ford taurus Check the ICU's before doing anything serious
Usually answered in minutes!
2,348 Questions
2,262 Questions
2,120 Questions
1,869 Questions
1,431 Questions