On the face of the microwave that displays the time, we just noticed ////////////along the bottom of the display under the time, we unplugged the microwave and tried to reset it, but no change ok if ...
Question about MHE14XKB Microwave Oven
Roper Microwave (mhe14xmq dec. 2003) trips breaker... Micro trips 15amp breaker under all different conditions. Electrician has checked electrical panel and the wire from micro to elec panel w/amp ...
Question about Spacemaker JVM1640SJ Microwave Oven
what screws do I loosen to get micro out of bracket. I need to tighten the bracket holding the micro. What screws do I loosen to remove micro so I can get to bracket? THE TOP SCREWS IN THE CABINET
Question about Spacemaker JVM1640SJ Microwave Oven
Installation of MM55541 Micromark Micro oven Can you tell me how much clearnce is required at the TOP of the micro, if it was put onto micro wall brackets 1 inch at the top for clearing the power cord
Can't remove the vent grill Manual instructs to reve screws from vent grill, tip the grill forward, lift out grill. Can't find the screws. Do you have to remove the entire microwave from the mounting?
...on the triangle in the center of the micro shut door and start micro observe if turning ..also some micros have a button selection on the control to reverse the micro plate rotation and stop it ...
try2910227 serial ywmh2205xvb-0 model arcing on the back corner were the rack sits.Is there a way to repair this seen is the unit was purchaced in June of 2011. Yes, take the rack out and recycle it. ...
humming noise from control panel when pluged in control panel hums This usually means that a micro switch is faulty, check the micro switch and replace if faulty, there should be two micro switches
micro does not turn on without external pressure we have a jvm1790sk01 - when we turn on the micro function it does not work - however if we press on the outer skin near display and even slightly ...
Question about GH4155XP Microwave Oven
My Daewoo Micro Wave Was Spitting Flames Last Night Due To A Hole In The Wave Plate Hello Stephanie. Get a new filter and try again. Otherwise scrap the micro. It the filter plate rusted through, or ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions