...doesn't bend like when using a normal stapler? Most of the staple gun models lack an "anvil" — the metal plate with curved slots that office staplers use to bend the legs of the staple inwards and ...
Question about 8000 Power Shot Pro Staple & Nail Gun
...after that... look towards the front end of the same top piece, and you'll see 2 holes in the metal. You need to push the spring up through the first hole, then pull it back down through ...
a few until I slowed my roll, took a deep breath and said, I have got to be smarter than a piece of metal here, and took a calm slow looksy. Sure enough, it was one loan staple causing a backup of the
cannot load staples At the back of the staple gun is a flat shaped metal piece. It's at the bottom. Push in, pull down, then pull the mechanism out. You'll see it's a metal rod with a spring, that is ...
how do I get to the top middle part of my metal how do I get to the top middle part (roof) of my metal shed to paint I cant reach it from a ladder? you could tie a brush to a broom stick. ive done ...
...corner. Pick up the stapler so that you are looked directly at this back-end. There is a small metal square at this corner that is spring-loaded and is held in place by a little hook. Push in on ...
...How do I do it? This stapler does not swing open like a paper stapler. It has a little square metal piece at its heel (about the size of a postage stamp). Press in lightly on this metal piece
...push rod into the staple channel of the gun. The end of the push rod has a small, solid piece of metal that fits into the staple channel. 4 Press the rod all the way into the staple gun until the ...
Question about 8x6 Newburgh Metal Garden Storage Shed Kit [NW86]
I have rain coming into my metal garage through the walls Try weather strippin around any possible gap or hot glue gun might also help
Usually answered in minutes!
65 Questions
25 Questions
28 Questions
15 Questions