Questions & Answers for: Radio Shack message code

...code. Enter a remote command (see ?Remote Commands? on Page 19). When you finish, press 5# to end remote access. REMOTE COMMANDS Note: When listening to messages in remote mode, there is a pause ...

code and then pressing 1# after the recorded message but my cell phone says, "call ended" and I don't get the messages. Any ideas? Check if message retrieval works with a landline phone. If that works

How do i check my messages from another an outside location because the code I was given no longer works The code has been changed. You will need to reset the code from the machine.

remote access code to retrieve messages How do you retrieve messages using the remote code listed on the product? The remote operation instructions are on the right half of the first page of the ...

Error message when trying to enter frequency codes into the Radio Shack Pro-433... How do I enter the frequency codes I have into this scanner? The error message almost always means that you have ...

the incoming message and single tone to end the incoming message. Entering the code "123" after the first tone does not do anything. What's wrong. Try the three-digit code on the bottom of the machine

...message. If I enter the security code of "123" followed by the command code of "2#" after the first tone or after the second tone, it does not work. I am not using a battery; does the remote checking ...

...by visiting: www.RadioReference.com Bill B. Listening in since the 60's How can I clear the message ALL ch

...be able to record a memo I think the two tones is a misprint. Most of the time you enter the code either while the outgoing message is playing, or immediately after the outgoing message

...message is playing, enter your remote operation security code. Bd appears on the display to indicate the system is in remote mode. If there are no new messages, you hear three beeps. These are the ...