Questions & Answers for: mercedes 8 15 truck

mercedes the crank sensor goes bad frequently. Its between the transmission and the engine on the drivers side about 11 o'clock position. You will need a internal torx 8 to remove the small screw that

Ad

Question about 1987 Mercedes Benz 190 Class

1 Answer

...15 live, now switch on the lights, is there another live? this is your lights or dimmer wire. with the lights and ignition on connect the live lide of your tester to the +30 wire and find one that is ...

Ad

...15 seconds The a/c blows through all the front vents for about 5-8 seconds then the a/c only blows through the driver and passenger vents and the middle nothing after the initial 5-8 seconds check ...

Question about 1999 C-Class

3 Answers

8 duel exhaust sitting at a red light, or RPM's were all over the place, would shutter and cut off at slow speed or at stops, if it could idle it would idle high, had to sit with one foot on the brake

...Mercedes C320 very poor fuel economy ~8 mpg, no engine codes or faults present I drive about 3 miles per day, 15 miles per week. The car has no engine codes or faults present when plugged into OBDII ...

...Mercedes C320 very poor fuel economy ~8 mpg, no engine codes or faults present I drive about 3 miles per day, 15 miles per week. The car has no engine codes or faults present when plugged into OBDII ...

8 to 10 amps, when on. If no reading volts, the glow plug relay, and maybe the plugs must be renewed. There should also be a big fuse at the firewall, check that also. Follow the glow plug wire, where

Mercedes SL500 03 Driver side fuse box number written?. Fuse Terminal Cable ID (fused) Fused function Rating in amperes (A) F1 30 - Wiper park position heater relay (K40/2kA) F2 30 - High pressure and

Mercedes. 115,000 miles. When it is left on tickover for 10 to 15 mins starts to smoke white/grey smoke from exhausts. After a few minutes of normal driving the smoke stops. No loss of performance and

...Mercedes Benz C300 V6 engine: Cylinder head bolts torque: 30 Nm (22 ft-lbs) + 90 degrees + 90 degrees (in 3 steps of 90 degrees each) Main bearing cap bolts torque: 30 Nm (22 ft-lbs) + 90 degrees ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...