...food cannot rotate. Is there any hope? You probably have a defective turntable motor. They are fairly simple to replace and generally runs about $30-$35. You can access the motor by removing the ...
plastic?? Quite often this is due to grease or food particles stuck to the inside of the oven or stuck on or behind the waveguide cover. The waveguide cover is usually about the size of a playing card
plastic coupling (Emerson part # M0R0688) has been discontinued with no replacement. The motor is part # M0S1033 at $36.99. You can continue using the oven even if the plate doesn't turn, but you have
Question about MW8625W Microwave Oven
...plastic ring with three wheels on it, that supports the glass tray of the turn table of my Emerson microwave oven, broke and is unusable. the purpose of the turntable is to more evenly cook the food. ...
food out. The door wouldn't open. I may have tried to open it while it was on. After reading manual I tried deactivating the child lock. It still wouldn't open. Any other tricks I can try? Thanks Your
plastic plate (It looks like it covers a hole, but I can not remove it) on side wall to burn/melt. Is it ok to continue using? The plate MIGHT cover the waveguide that brings the microwave energy into
I placed food in the microwave over to heat for 19 seconds, when it was finished I smelled smoke coming from the oven. The food was fine. I unpluged the oven. I tried it a couple of days later, it ...
Question about 025806092806 Microwave Oven
...plastic film inside the window on the door is pulling away from the glass. Does this consttute any danger. Does it or the micrwave have to be replaced? Other than that the microwave works perfectly. ...
...plastic cover on the door stops food particles and steam entering the inside part that is not easily cleaned. That's all. It is like thick selotape. as long as there is no metal or metalic surfaces ...
Question about 025806092806 Microwave Oven
melted bit of plastic under the blasde for the terminal, you can bet the connection over heated and melted the switch. Just replacing the switch wont cure the problem. I usually add in a small sevtion
Usually answered in minutes!
228 Questions
106 Questions
114 Questions
84 Questions
52 Questions