Questions & Answers for: GMC melted plastic food

to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order

Ad

no brake lights on 1995 gmc 1/2 ton switch ok all other lights work stop lamprelay has power check for corossion at rear taillight receptacles I will give it a shot Gm has had some issues with the ...

Ad

Question about 2001 Sonoma Extended Cab

2 Answers

...plastic is melted out the u-Joint can be pressed out with a press or a ball joint press that can be rented at an auto prts stroe the other answer is to take the shaft to a machine shop and have them ...

Question about 2001 Yukon XL

1 Answer

...the larger connector, to check for any melted terminals, or burnt plastic. If damaged, it would have to be replaced, the resistor has to be replaced either way. Both available at a Chevy, or GMC ...

Question about 1985 Jimmy

1 Answer

i need a spark plug wire diagram for a 1985 gmc jimmy 350 engine Most all Chev or GMC v8 engines use the firing order of 1-8-4-3-6-5-7-2. You have to find where #1 is on the distributor cap which is ...

...the larger connector, to check for any melted terminals, or burnt plastic. If damaged, it would have to be replaced, the resistor has to be replaced either way. Both available at a Chevy, or GMC ...

...melted plastic, I would like a second opinion. it will be burnt wire and around the ignition switch burnt wires are obvious but be smart only an accredited auto electrician should be used to locate ...

...in . Trying to remove the drive shaft on the rear but it won't come out. All U joints are pressed in. Some GM drive shafts have a plastic ring holding in the caps. It has to be melted out

...plastic with donor plastic from a heavy food grade plastic bottle. And let me tell you, This (plastic welding) is a majorly useful skill, and is actually the principle that hot glue works

...isn't melted also, very common for the pigtail plastic to melt on the inside and short out. When replacing the module or resistor, always replace the pigtail that goes into it. Common for it to

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...