Questions & Answers for: Chevrolet measurement Cars & Trucks

...then measure back to the center of the rear wheel on the same side and you have your wheelbase measurement. Thanks for using

Ad

Question about 1996 Cavalier

1 Answer

...off the wire connection to the alternator. Take off the car key. Use a Multimeter set to current measurement To measure in series from the positive terminal of the battery to the positive cable. ( ...

Ad

I changed my 1994 camaro trans to a turbo400. Idon't know what u-joint to get for the different yoke Take the yoke and driveshaft to your parts store. They will measure it out for you. If you have an ...

wrecked 2004 suburban how do you measure the frame to see if it is bent , car was hit on passenger side bent frame horn to the right. set off the air bags. Well you can measure from the lower front ...

how many temp sensors does a 2000 s10 truck have and what do they do two or three. one for the idiot light, measures coolant temp. one for the pcm and the gauge. measures coolant temp also, one for ...

How do u read the transmission fluid gauge. Most have 2 marks or notches. You need to let your car warm up for about 10 mintues and then measure it. The levels need to be between the marks. Some ...

Question about 2000 Silverado 1500

1 Answer

What measurements can I use to line up the headlights on a 2000 Chevy Silverado when I line up on a wall? i always measure the center of headlights up from the ground. then i put vehicle 10 feet from ...

Question about 2000 Silverado 1500

1 Answer

My 1990 chevy astro van didn't pass smog. Paperwork says it failed the following; Ignition timing: 99 ATDC. Also, ASM Emission Test Results; 15mph HC (PPM) max is 122 measured 127, 25mph max is 102 ...

...is reverse on removal.note measure tires front and back of hub and adjust new tie rod ends to same measurement, also youll need to take it in for an alignment once your done, however measuring and ...

...you will need a 1" af socket if it is a metric nut then measure across the flats and then take the measurement to a good tool shop and find a socket that has that measurement across the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...