Mazda Protege ABS & Brake light ABS & Brake light are staying on. This happened a few days or weeks after the brakes were changed. It is most likely caused by one of the ABS wheel speed sensors, those
...ABS system needed replacing. You can determine which one is broken by putting volt meter over each of them. I have a Mazda Capella (626) 1998 and had similar problem other than it was running on 4 ...
...bearings,I had same problem,I replaced every thing before I found the bearing problem. I have had the same problem with my 2003 Mazda 6. It was a misaligned abs sensor on the passenger side
mazda 626 abs computer/module Hi does anyone know where on the car is the abs computer/module? my abs light stays on and a diagnostic tool suggests that there is a fault in the computer.control module
...mazda B3000 2 wheel drive the abs light came on and the speedometer starting acting up where it won't work until I reach 40mph. is it the speed/abs sensor in the back axle vice versa.. speedometer ...
...ABS light on my 2003 Mazda Tribute just came on; it has never done this before. it may be a bad abs sensor. i would go to a mechanic that has a dignostic machine. it will tell you if sensor is bad or ...
mazda 2 abs warning come on removed all 4 tire to check & clean all abs sensor them if sensor looks fine check the abs systen is under the brake booster if after all this thing the warning lite ...
...ABS lights on dashboard are staying on Mazda Tribute or Ford escape If you check abs code it say a defective Wheel sensor but it isn`t It is a crack sensor gear on axle check it is loose coast $9.00 ...
...Mazda Tribute, ABS light on 4wd flashing. I know it's most likely a sensor and I plan on getting it scanned. However I just replaced the ECM, plugs and coils and alternator. Is there a chance the ABS ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions