Questions & Answers for: Whirlpool maytag washer thumping

Washer makes loud thumping after finished spin cycle My top loading Whirlpool washing machine makes a loud thumping sound at the end of the first spin cycle as it is winding down just before refilling

Washer makes a thumping sound When washing towels on the "quick wash" cycle, when agitating the machine makes a thumping sound on the side. I had the repairman out and he ran it through diagnostics ...

...thumping during the spin, the load of clothes may have become unbalanced. Stop the washer and redistribute the clothes, then re-start it. Repeat these steps if necessary. If there's a loud thumping ...

...washer and dryer that they were very quiet, well I guess this was not true. The thumping is getting louder and louder. if it is less then 6 months old you need to call whirlpool and they will send a ...

Machine makes a thumping noise when spinning When sppin cycle starts the machine makes a thumping sound like it is out of balance or bad bearing.... If its thumping you have the maching overloaded and

...thumping sound in the wash cycle but not during the spin cycle. Seems to thump a little louder with every load. Any suggestions? This washer has a very complex ujoint system that make the wash plate ...

...washer has a thumping noise? First, make sure that the dishes aren't rattling around inside the washer. Believe it or not, your Kenmore Front Load Washer user's manual will have instructions on the ...

during deceleration after spin cycle there is a loud thump,thump every 180 degrees of tub rotation.Can i easily repair this and what are the estimated parts cost? I assume that you have checked how ...

washer is thumping during spinning, this is probably the motor drive or the spin bearing. This would cause a lot of noise. Your washer will act up if it is not balanced right. Check the floor and make

...washer makes a thumping sound (not actually thumping, though) and does not get to full spin speed. It does spin, just not fast. What could the problem be? You can check the belt, pulley, and the ...