Maytag front load 9700 Control lock light is on. Cannot use the control knob. Have unplugged machine, but "control lock" light stays on First things first... please follow this link to see if your ...
Question about EPIC MFW9700S Front Load Washer
the ''control locked light is on'' how do i reset it on a maytag frontloader there is a button on the control panel, marked "control lock" hold for 3 secs to unlock, look closely its there
Question about EPIC MFW9700S Front Load Washer
maytag front loader washer, control lock light is on. how do i turn it off? You have to hold down the lock button on the control panel for 3or 4 seconds it should turn off
Question about Neptune MAH5500B Front Load Washer
...in electronic repair and soldering, try checking ebay for the control board repair kit. Search for "MAYTAG NEPTUNE WASHER R11 Q6 REPAIR KIT". It has all instructions how to do the repair. Good
Question about Neptune MAH5500B Front Load Washer
...Maytag MSD2351 side by side and just replace the water filter. When I attempted to reset the filter light, the control locked and I can not get it to unlock. I pressed the lock and water button ...
Question about Neptune MAH5500B Front Load Washer
...lid repeatedly but won't start maytag mvwx550xw1 washer .Lid lock switch appears to try to engage over and over. Light for lid lock flashes and machine will not start you might need a new control ...
Question about Neptune MAH5500B Front Load Washer
...Control Lock light on my Maytag 5000 Series dryer is flashing, and the dryer makes an error beep when I try to start it. The flashing is NOT normal, as the light is normally solid when locked or off ...
Question about Neptune MAH5500B Front Load Washer
Maytag dryer control is locked. how do I unlock it? Press and hold for 3 seconds the "Control Lock/Unlock" button on the control panel to unlock the control panel. The "Control Lock" status light goes
Question about Neptune MAH5500B Front Load Washer
Maytag Control Locked error model # MFW9700SQ1 Control locked lights on. I tried long press the Start button but still not working Holding the Cycle End Signal button for 3 seconds is the way to turn ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions